NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 15
5. Position the remaining collar assembly with the interface of the ATM, as shown. At
the same time, feed the facia light harness connector (labelled “Advert Light”)
through the hole in the collar assembly.
6. Position the vertical side brackets until the slots line up with the holes in the ATM
sleeve chassis, then loosely fit at each side using three M4 x 6 taptite screws. Make
sure the top collar is aligned with the ATM facia, adjusting where necessary to ensure
there are no visible gaps, before tightening all six screws.
7. Perform the following steps to fit the ambient light panel:
a Connect the facia light harness connector to the light panel harness connector.
To Next Page
Loading...
