NCR SelfServ 34 ATM Installation Guide
16 B006-6590-C000
b Locate the light panel within the clips at the top of the collar assembly, then push
the panel back to secure within the bottom clips.
c Fold the harness and connectors and place vertically adjacent to the light panel.
8. Perform the following steps to fit the advert window bezel:
a Locate the tabs on the window bezel into the three slots in the top of the collar
assembly. Push the bezel back into position, securing in place using three M4 x 12
tamper-proof screws.
b Locate the three tabs on the plastic blanking cover into the holes in the advert
window bezel then clip in place, covering the tamper-proof screws.
Note: A security screwdriver bit (supplied in the collar box) is required to install the
tamper-proof screws.
To Next Page
Loading...
