NCR SelfServ 34 ATM Installation Guide
B006-6590-C000 27
5. Position the collar assembly with the interface of the ATM as shown. At the same
time, push the facia light harness connector (labelled “Advert Light”) through the hole
in the collar assembly.
6. Position the vertical side brackets until the slots line up with the holes in the ATM
sleeve chassis, then loosely fit at each side using three M4 x 6 taptite screws. Make
sure that the top collar is aligned with the ATM facia, adjusting where necessary to
ensure that there are no visible gaps, before tightening all six screws.
To Next Page
Loading...
