NCR SelfServ 34 ATM Installation Guide
28 B006-6590-C000
7. Secure the collar hood to the ATM facia using five M4 x 8 plastite panhead screws.
8. Perform the following steps to fit the ambient light panel:
a Connect the facia light harness connector to the light panel harness connector.
b Locate the panel within the clips at the top of the collar assembly, then push the
panel back to secure within the bottom clips.
c Place the harness and connectors below the light panel. Push any excess harness
back through the facia hole. Use a cable tie to secure any other harness connectors
which are not required.
To Next Page
Loading...
