NCR SelfServ 34 ATM Installation Guide
30 B006-6590-C000
10. Refit the two vertical collar mouldings removed earlier. Locate the interlocking tabs
on the mounting assembly with the slots on each of the vertical collar mouldings as
shown below, then slide upwards into position.
Note: If a consumer mirror kit is present, at this stage, replace the vertical collar
moulding with the mirror vertical collar mouldings according to the kit instructions.
11. Make sure that all of the collar parts are as tight as possible and that there are no
visible gaps between the collar and the facia. Secure with two M4 x 6 machine screws
removed earlier.
To Next Page
Loading...
