EasyOne Pro™ / EasyOne Pro™ LAB 103
Hygiene, Cleaning, Maintenance, Disposal
Software Update
The files necessary for a software update are made available by ndd. For a
detailed description of the installation procedure, please go to www.ndd.ch,
Application Note “Update EasyOne Pro Firmware” or “Update EasyOne Pro-
LAB Firmware”.
Note
Before installing the update, close Adobe Reader or the
Operator's Manual.
These are the steps of the installation procedure:
1. Data backup
Save the patient data to a USB flash drive (memory stick).
2. Preparation
Download the most recent revision of the EasyOne Pro software from
the ndd website:
http://www.ndd.ch/Downloads/Software.aspx and copy the data to a
USB flash drive (memory stick).
3. Software Update
Connect the USB flash drive to EasyOne Pro™.
Click Utilities -> Advanced.
Enter the password (EOPTM or 8005).
Click Software Update and double-click the update file on the USB
flash drive.
Follow the on-screen instructions.
4. Check settings
Check whether the sensor symbol is displayed.
5. Check function
Perform a calibration test (Utilities -> Calibration test).
Calibrating the Touch Screen
When you notice that you are no longer able to activate system functions by
touching the keys or fields on the display or that the positions have moved,
it is necessary to calibrate the touch screen:
On the initial screen, select Utilities -> Advanced and enter the password
(EOPTM or 8005).
Select Touch calibration.
In the ensuing window, select Configure -> Standard Configuration and
follow the displayed prompts.
To Next Page
Loading...
Need help?
General
