To Next Page

To Previous Page

EasyOne Pro™ / EasyOne Pro™ LAB 37

Start-up and Initial Preparation

spirette™

Note

The device is to be operated only with the original ndd

spirette™.

Warning

Cross Contamination Between Patients—The spirette™ is

intended for single patient use. Use a new one for each

patient to prevent cross contamination between patients.

 Tear open the plastic bag containing the spirette™ and fold the bag back

so that you can insert the spirette™ in the flow sensor. Ensure that the

plastic bag protects the mouthpiece of the spirette™ until you hand the

flow sensor over to the patient.

This approach not only ensures perfectly hygienic conditions, it also keeps

the spirette™ closed for subsequent setting of the baseline.

 Insert the spirette™ - as shown in the illustration - into the flow sensor

as far as possible. When doing this, please ensure that the arrow on the

spirette™ is lined up with the arrow on the flow sensor.

 You remove the spirette™ by pushing it out of the sensor from below.

Fig. 2-21 Inserting the FRC barriette™

Questions and Answers:

Need help?

Do you have a question about the NDD easyone pro and is the answer not in the manual?

NDD easyone pro Specifications

General