EasyOne Pro™ / EasyOne Pro™ LAB 81
Performing a Test
Note
The parameter names used by ndd Medizintechnik AG are
those standardized by ATS and ERS. (See literature
references [14] and[11] ("Literature" on page 182).
For forced spirometric tests and depending on your configuration, the
"Best" column in the result table shows the "Best Value" of all accepted tri-
als or the "Best Trial", i.e., the value of the best trial ("Test Tab" on
page 116).
The most important parameters will be explained below:
For slow spirometry (SVC), the mean value of the accepted trials will be
shown with the following exceptions: VT, ERV, IRV, IC.
For DLCO, the mean values will be displayed in the "Result" column for the
following parameters: DLCO, VA, TLCO, DLAdj and TLC.
IC Inspiratory Capacity inspiratory capacity
(VT + IRV)
MVV Maximum Voluntary Venti-
lation
maximum ventilation vol-
ume per minute
LLN Lower Limit of Normal lower limit of normal
Lung Age lung age, see section "Pre-
dicted Values" on
page 139 [8]
DLCO CO diffusing capacity
(ml/min/mmHg)
CO diffusing capacity
(ml/min/mmHg)
TLCO CO diffusing capacity
(mmol/min/kPa)
CO diffusing capacity
(mmol/min/kPa)
DLadj Diffusing capacity
adjusted (Hb, PaO
2
, COhb,
altitude)
adjusted diffusing capac-
ity
VA Alveolar volume (BTPS) alveolar volume (BTPS)
VI Inspiratory Capacity from
DLCO maneuver
inspiratory capacity from a
DLCO test
DLCO/VA Krogh Factor Krogh factor
TLC Total Lung Capacity total lung capacity
To Next Page
Loading...
Need help?
General
