NEC Express5800 1160Xd - Page 98

3-42 Service Processor
Table 3-35 HC Subcommands (cont’d)
cmd arg1 arg2 arg3 arg4 Description
mmcxy
(cont’d)
cachez
- - Enables the Cache.
“z” is the Cache number (0-7).
tagx[sy]
- - - Enables the TAG.
“x” is the physical CELL Board number (0-7).
“s” is either “e” (EVEN side) or “o” (ODD side).
“y” is the TAG number (0-3).
When “sy” is omitted, all the TAGs under the
CELL Board specified by “x” become enabled.
pcixx
all - - Enables the Full/Half-size PCIX Unit.
“x” is the DGI/I2C cable port number (0-7) of the
cable from the ISPC Board to the Full/Half-size
PCIX Unit.
“all” must be specified as the second argument.
Then, not only the PCIX Unit but also its
subcomponents become enabled.
[all] - - Enables the IOR Daughter Board.
“x” is the physical IOR Daughter Board number
(0-7).
When the second argument is omitted, only the
IOR Daughter Board is enabled, and the states
of any other subcomponents do not change.
When “all” is specified as the second argument,
not only the IOR Daughter Board but also its
subcomponents become enabled.
nciy
- - Enables the NC interface part.
“y” is the interface number (0-1).
It coordinates with the interface part in the
opposing XBC Board, NC1/NC2 Board, or IOR
Daughter Board.
enable
(cont’d)
iorx
iocy
- - Enables the IOC.
“y” is the IOC number (0 or 1) within the IOR
Daughter Board.