NEC Express5800 1160Xd - Page 99

Service Processor 3-43
Table 3-35 HC Subcommands (cont’d)
cmd arg1 arg2 arg3 arg4 Description
- - - Enables the GXB.
“x” is the DGI/I2C cable port number of the
cable from the iSP to the Full/Half-size PCIX
Unit (0-7).
“y” is the GXB number (0-3) within the Full/Half-
size PCIX Unit.
enable
(cont’d)
gxbxy
busA
|busB
- - Enables the busA side and busB side of GXB.
- - - - Used to disable a component manually.
Displays Help for “disable” when the argument
is omitted or an error is made.
If the component is online state, the component
can not be disabled.
disable
<arg1> <arg2>
- -
<arg1> and <arg2> are the same as described
in “enable” above.
“all” cannot be specified.
- - - - Used to dynamically configure an offline
component while the OS is running.
This command functions only with the support of
the software (OS and BIOS).
This SP command may be unnecessary
depending on the OS.
Displays Help for “online” when the argument is
omitted or an error is made.
cellx
- - - Configures the CELL Board for the OS.
xbcx moverx
- - Configures the XBC Board’s mover for the OS.
online
iorx
- - - Configures the IOR Daughter Board for the OS.
- - - - Used to dynamically delete an online
component while the OS is running.
This command functions only with the support of
the software (OS and BIOS).
This SP command may be unnecessary
depending on the OS.
Display Help for “offline” when the argument is
omitted or an error is made.
offline
<arg1> <arg2>
- - Same as described in “online” above.