NEC Express5800 1160Xd - Page 100

3-44 Service Processor
Table 3-35 HC Subcommands (cont’d)
cmd arg1 arg2 arg3 arg4 Description
- - - - Used to set connection information of the 1.6G
cable.
Displays Help for “ncconn” when the argument
is omitted or an error is made.
This subcommand can be executed when all
partitions are in the DC POWER OFF state.
xbcx nciy iors ncit
iors ncit xbcx nciy
Specifies the connection between the 1.6G port
with the port number y in the XBC Board with
the physical number x and the 1.6G port with
the port number t in the IOR Daughter Board
with the physical number s.
ncconn
iors ncit ioru nciv
Specifies the connection between the 1.6G port
with the port number v in the IOR Daughter
Board with the physical number u and the 1.6G
port with the port number t in the IOR Daughter
Board with the physical number s.
- - - - Used to disconnect the 1.6G cable.
Displays Help for “ncdis” when the argument is
omitted or an error is made.
This subcommand can be executed when all
partitions are in the DC POWER OFF state.
xbcx nciy
- - Removes the connection of the 1.6G port with
the port number y in the XBC Board with the
physical number x.
It is linked to the disconnection of the
corresponding NC1/NC2 Board/IOR Daughter
Board port (and vice versa).
ncdis
iors ncit
- - Removes the connection of the 1.6G port with
the port number t in the IOR Daughter Board
with the physical number s.
It is linked to the disconnection of the
corresponding NC1/NC2 Board/IOR Daughter
Board port (and vice versa).
- - - - Used to turn on/off a component’s LED to
identify its location.
Displays Help for “led” when the argument is
omitted or an error is made.
clkx
on|off - - Turns on/off the LED of the CLK Board.
“x” is the physical CLK Board number (0-1).
led
xbcx
on|off - - Turns on/off the LED of the XBC Board.
“x” is the physical XBC Board number (0-3).