NEC Express5800 120Li - Menu Tree

4-36 Configuring Your Server
Menu Tree
Setting list
+: Selection/execution parameter : Setting parameter. •: Information display
>: Can be set (modified) after creation of logical drive
Menu Description
+Configure Performs Configuration settings
+Easy Configuration Set configuration (Using fixed value)
+New Configuration Set new configuration
+View/Add Configuration Additional setting / viewing configuration
+Clear Configuration Clear configuration
+Select Boot Drive Chose Bootable Logical Drive
+Initialize Initialize logical drive
+Objects Various settings
+Adapter Set disk array controller
+Sel. Adapter Clear configuration
Rebuild Rate 30
Chk Const Rate 30
FGI Rate 30
BGI Rate 30
Disk WC WT
Read Ahead On
Bios State Enable
Stop on Error No
Fast Init Enable
Auto Rebuild On
Auto Resume Enable
Disk Coercion 1GB
Factory Default
+Logical Drive Logical drive operation
+Logical Drives Select lo
g
ical drive
(
when multiple lo
g
ical drives exist
)
+Initialize Initialize logical drive
+Check Consistency Check logical drive redundancy
+View/Update Parameters Display logical drive information
• RAID Display RAID level
• SIZE Display logical drive capacity
• Stripe SIZE Display stripe size
• #Stripes Displa
y
the number of hard disk drives in lo
g
ical drive
• State Display logical drive status
• Spans
• Disk WC Off: Write through
On: Write back
• Read Ahead
+Physical Drive Physical drive operation
+Physical Drive Selection Menu Select physical drive
+Make HotSpare Set as hot-spare disk for auto rebuilding
+Force Online Make a disk online
+Force Offline Make a disk offline
+Drive Properties Display hard disk drive information
• Device Type Hard disk drive type
• Capacity Hard disk drive capacity
• Product ID Hard disk drive model
• Revision No. Hard disk drive revision
+Rebuild Perform rebuilding
+Check Consistency Perform logical drive redundancy check