10-4 Internal Cabling Diagrams
Installing Internal SCSI File Device
To install the internal SCSI file device, you need prepare a separately priced SCSI controller and
SCSI cable.
IMPORTANT:
Up to two SCSI devices can be installed in the server.
To install two half-height SCSI devices in the 5.25-inch device bay,
move the factory-installed DVD-ROM drive to the top bay.
SCSI controller: N8103-75F, N8103-95
SCSI cable: K410-68 internal SCSI cable
K410-68 internal SCSI cable is equipped with terminating resistor. Set "Disabled" for all the
terminating resistors of connected devices. For other setting, refer to the manual provided with the
device.
A file device needs settings such as a SCSI transfer rate. For the transfer rate, see the manual
provided with the file device. Use the BIOS utility of the SCSI controller to make the settings. For
details, see the manual provided with the SCSI controller.
DVD-ROM
SCSI device
SCSI device
5.25-inch
device bay
3.5-inch hard
disk drive bay
Hard disk drives
are optional.
Mother board
PCIe #5
PCIe #4
PCIe #3
PCI #2
PCI-X #1
HDD cage
(optional)
SAS cable SCSI cable IDE cable
SCSI controller
To Next Page
Loading...
