4-50 Configuring Your Server
Clearing Password
1. See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2. Remove the side cover.
3. Remove the jumper strap on the BIOS password clear jumper.
IMPORTANT: Keep the removed jumper strap for future use.
4. Reinstall the side cover removed in Step 2.
5. Plug the power cord to your server and turn on the server.
6. POST stops at the error message shown below.
ERROR
B151 Password Cleared By Jumper
Press <F1> to resume, <F2> to Setup
7. Turn off the power of the server. Install the jumper strap removed in Step 3.
8. Reassemble the server.
To Next Page
Loading...
