NEC Express5800 120Li - Event Log; External Devices

Configuring Your Server 4-7
CPU
To check the installed CPU status
Select [Main] - [Processor Settings] and check the status indications.
The on-screen processor numbers and socket locations on the motherboard are associated
as shown in the figure on the previous page.
To clear the CPU error information
Select [Main] - [Processor Settings] - [Processor Retest] – [Yes] and reboot.
Keyboard
To set Numlock
Select [Advanced] - [Numlock] – [On]/[Off].
Event Log
To clear event logs
Select [Server] - [Event Log Configuration] - [Clear all Event Logs], press Enter, and
select [Yes].
Security
To set passwords on the BIOS
Select [Security] - [Set Supervisor Password] and enter a password.
Select [Security] - [Set User Password] and enter a password.
Set Supervisor password first, then User password.
External Devices
To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To install the disk array controller board or SCSI controller board
Select [Advanced] - [PCI Configuration] - [PCI Slot n Option ROM] - [Enabled].
n: slot number
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes].