10-6 Internal Cabling Diagrams
Connecting with External SCSI Device
To install the internal SCSI file device, you need prepare a separately priced SCSI controller and
SCSI cable.
Assign the unique SCSI ID to each device. Enable the terminating resistor of the last device of the
connection. (If no device is connected, installing a terminating resistor on the rear connector is not
required.) The total cable length (including internal cable) must be 3 m or shorter.
IDE device
DVD-ROM
5.25-inch
device bay
3.5-inch hard
disk drive bay
Hard disk drives
are optional.
Mother board
SAS cable IDE cable
SCSI controller
PCIe #5
PCIe #4
PCIe #3
PCI #2
PCI-X #1
To Next Page
Loading...
