Configuring Your Server 4-37
Operating Procedures for Setup Utility
Creating/Adding Configuration
Run LSI Logic Software RAID Setup Utility
Set new configuration information (pack/logical drive settings)
Check the logical drive settings
Initialize logical drive
Perform Consistency Check
Exit LSI Logic Software RAID Setup Utility
1. Run LSI Logic Software RAID Setup Utility.
2. Select "Configure" → "New Configuration" from the TOP menu (Management Menu).
Select "View/add Configuration" to add configuration.
IMPORTANT:
Creating a configuration using "New Configuration" menu clears
the existing configuration information. To add configuration
information to the existing configuration, select "View/Add
Configuration."
You cannot create Spanning of RAID1 and RAID5, or set the
logical drive capacity on "Easy Configuration" menu.
Use "New Configuration" or "View/Add Configuration" instead.
To Next Page
Loading...
