Configuring Your Server 4-31
RAID10 (spanning of RAID1)
RAID10 is a RAID level combined with RAID0 and RAID1.
Stores data on hard disk drives by dividing it (striping). Then, each striped data is written
onto hard disk drives in mirroring mode. Owing to this feature, high disk access
performance of RAID0 and, in addition, high reliability of RAID1 can be achieved.
IMPORTANT: Logical capacity of the array is equal to one hard disk
drive connected.
Installing the Hard Disk Drives
Install the two or more SAS hard disk drives to your server. See Chapter 9 for detail.
IMPORTANT: Use two hard disk drives of the same revolution. In
addition, use two hard disk drives of the same capacity if you are going
to configure RAID1.
To Next Page
Loading...
