General Description 2-5
1 5.25-inch device bay
Backup tape drives may be installed in the 5.25-inch device bay.
2 DVD-ROM drive
The DVD-ROM drive reads data from the inserted CD/DVD-ROM.
2-1 Access lamp
2-2 Tray
2-3 Emergency hole
2-4 Open/Close button
3 3.5-inch hard disk drive bay
The 3.5-inch hard disk drive bay contains slots for adding hard disk drives having thickness of
about 1 inch.
SCSI IDs are fixed to ID0 - ID3 from bottom to top. Hard disk drives are sold separately.
Dummy trays are inserted into the empty slots (excluding the slot of ID0).
4 Cover open sensor
The cover open sensor detects the open of the front door.
5 Power switch
The power switch is used to turn on/off the power. If you press the switch once, then the
POWER/SLEEP lamp goes on and the power is turned on. If you press the switch again, the
power is turned off. The system is forcibly shut down when the power switch is pressed
continuously for four seconds or longer.
6Lamps (see the figure on the previous page)
7 Reset switch
The reset switch is used to reset the server.
8 Dump switch (NMI switch)
The dump switch is used to collect the event logs having occurred in the server.
9 USB connectors
The USB connectors allow the server to connect with devices meeting the USB interface.
10 Additional HDD cage bay
Installing an optional HDD cage allows the server to be equipped with up to eight hard disk
drives.
To Next Page
Loading...
