Configuring Your Server 4-43
Setting Hot Spare
Install a hard disk drive
Run LSI Logic Software RAID Setup Utility
Set for hot spare.
Exit LSI Logic Software RAID Setup Utility
1. Install a hard disk drive to be used as hot spare, and then turn on the server.
2. Run LSI Logic Software RAID Setup Utility.
3. Select "Objects" → "Physical Drive" from the TOP menu.
The "Objects - PHYSICAL DRIVE SELECTION MENU" screen appears.
4. Move the cursor onto the hard disk drive to be used as hot spare and press Enter.
5. The "Channel X, Target X" screen appears. Select "Make HotSpare."
6. A confirmation screen appears. Select "Yes."
The hard disk drive indication is changed to "HOTSP."
To Next Page
Loading...
