Upgrading Your Server 9-45
Installation
Install a CPU in the following procedure.
IMPORTANT: Any CPU is easily affected by static electricity.
Handle a CPU after making your body contact with a metallic frame
section of the server to discharge the static electricity on your body. Do
not make bare hands contact with the CPU pins. In addition, do not put
any CPU on a desk directly. See "Static Precautions" for details of the
static electricity.
1. See the section "Preparing for Installation and Removal" described earlier to prepare.
2. Remove the components as follows:
Side cover
CPU duct cover
3. Locate the CPU socket which you are going to install CPU.
4. Remove the CPU cover.
5. Raise the locking lever on the socket.
IMPORTANT: Open the lever until it stops. The bar can be opened to
120 degrees or more.
To Next Page
Loading...
