Installing Windows Server 2003 E-7
7. Select the proper SCSI Adapter and press Enter.
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-91 board is installed.)
– [LSI Logic MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)]
(When N8103-99 board is installed.)
– [LSI MegaRAID Software RAID (Windows XP/2003)]
(When LSI Logic Embedded MegaRAID is installed.)
Continue performing tasks according to the subsequent messages that appear.
8. When the following message is shown, press Enter to start "Welcome to Setup".
9. When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has installed: Go on the step 13
– Windows Server 2003 R2 has installed: Go on the step 10
10. When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be
displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after
the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2.
In this case, note that the [Windows setup] screen is not displayed.
To Next Page
Loading...
