Configuring Your Server 4-33
1. See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2. Remove the side cover (see Chapter 9).
3. Locate the position of the RAID configuration jumper on the mother board as shown
below.
4. Remove the jumper from position 1 – 2 on jumper block.
5. Reinstall the jumper on position 2 – 3 on jumper block.
6. Reinstall the server removed in Step 2.
7. Plug the power cord to your server and turn on the server.
Rear
RAID configuration jumper
Front
RAID
disable
RAID
enable
To Next Page
Loading...
