NEC Express5800 320Fd-MR - Page 102

4-12 System Configuration
I/O Device Configuration
When you select “I/O Device Configuration” in the Advanced menu, the following screen appears.
If you select a menu with the “►” mark and press Enter, its submenu appears.

Refer to the table below for information on options.
  
Option Parameter Description
Serial Port 1
Enabled
[Disabled]
Auto
Specify whether or not to enable Serial Port 1.
Base I/O address
[3F8/IRQ4]
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Specify the I/O address and IRQ of Serial Port 1.
Serial Port 1 Connection
[Serial
Connector]
Internal
Modem
Specify Serial Connector or Internal Modem for
Serial Port 1 connection.
Serial Port 2
Enabled
[Disabled]
Auto
Specify whether or not to enable Serial Port 2.
Base I/O address
3F8/IRQ4
[2F8/IRQ3]
3E8/IRQ4
2E8/IRQ3
Specify the I/O address and IRQ of Serial Port 2.
Serial Port 2 Sharing
Enabled
[Disabled]
Specify whether or not to use Serial Port 2 in
BMC.
MainAdvancedSecurityServerBootExit
ftServerSetup
F1Help↑↓SelectItem-/+ChangeValuesF9SetupDefaults
EscExit←→SelectMenuEnterSelectSub-MenuF10SaveandExit
I/ODeviceConfiguration ItemSpecificHelp

ConfigureSerialPort1
usingoptions:

[Disabled]
Noconfiguration
[Enabled]
Userconfiguration
[Auto]
BIOSorOSchooses
configuration

NOTE:
SerialPort1maynot
beroutedtotheModem
ifaVTMispresent.

SerialPort1:[Enabled]

BaseI/Oaddress:[3F8/IRQ4]
SerialPort1Connection:[SerialConnector]
SerialPort2:[Enabled]
BaseI/Oaddress:[2F8/IRQ3]


SerialPort2Sharing[Disabled]

KeyboardFeatures:

NumLock:[Off]