System Upgrade 8-7
Removing CPU/IO Module
Follow the procedure below to remove the CPU/IO module.
1. Stop the CPU/IO module you want to remove.
To this end, use the ftServer Utility of the NEC ESMPRO Agent installed to your server or the Data
Viewer of the NEC ESMPRO Manager.
For the detailed procedure, see “NEC ESMPRO Agent and Manager” – “Maintenance of NEC
Express5800/ft series” in Chapter 5.
NEC ESMPRO Manager
Select [ft] - [CPU Module] - [CPU Module (to be
removed)] - [Maintenance] - [Bring Up/Bring
Down] - [Bring Down].
ftServer Utility
Select [FTServer] - [CPU Module] - [CPU Module (to
be removed)] - [Bring Up/Bring Down] - [Down].
Repeat the operation mentioned above for the PCI module and confirm that the status of the
CPU/IO module and the PCI module are “Removed.”
TIPS:
When removing CPU/IO modules 0, select [Bring Down] for CPU module (ID:0) and PCI
module (ID:10)
2. Remove the front bezel
To Next Page
Loading...