8-4 System Upgrade
PRE-UPGRADE VERIFICATION
If you add on optional devices onto this equipment, some devices may require a specific ft server
software version (s).
If the optional device asks for a specific version number (s), refer to the following procedure before
adding on the devices.
1. Confirm the required ft server control software’s version by referring to the sever-accessory
User’s Guide, check the NEC website, or contact your sales representative.
2. Verify the version of the ft control software on your system.
3. After confirming the version as the available one for the device, add the device onto the server.
For more information on how to verify the working ft server utilities, refer to the separate User’s Guide
(setup) “Confirming of the ft Server Control Software Version” (page 5-10).
To Next Page
Loading...