NEC Express5800 320Fd-MR - Console Redirection

System Configuration 4-23
Console Redirection
Select “Console Redirection” on the Server menu and press Enter to display the following screen.
See the table below for setup options on the screen.
Option Parameter Description
Com Port Address
[Disabled]
Serial Port1
Serial Port2
Select a serial port.
Baud Rate 9600
[19.2K]
38.4K
57.6K
115.2K
Select a port rate used for the interface with a
hardware console to be connected.
Console Type
VT100
VT100, 8bit
PC-ANSI, 7bit
[PC-ANSI]
VT100+
VT-UTF8
Select a console type.
Flow Control None
XON/XOFF
[CTS/RTS]
Select a flow control method.
Console Connection
[Direct]
Via modem
Select a connector.
Continue C.R. after
POST
[Off]
On
Specify whether or not to continue Console
Redirection after OS is loaded.
[ ]: factory default
MainAdvancedSecurityServerBootExit
ftServerSetup
F1Help↑↓SelectItem-/+ChangeValuesF9SetupDefaults
EscExit←→SelectMenuEnterSelectSub-MenuF10SaveandExit
ConsoleRedirection ItemSpecificHelp

Ifenabled,itwill
useaportonthe
motherboard.

ComPortAddress[Disabled]

BaudRate[19.2K]
ConsoleType[PCANSI]
FlowControl[CTS/RTS]
Consoleconnection:[Direct]
ContinueC.R.afterPOST:[Off]