General Description 2-21
Power ON
To power on NEC Express5800/ft series, press the POWER switch (the one whose in-built LED is
illuminating).
Follow the steps below to turn on the power.
1. Power on the display unit and other peripheral devices connected to the server.
CHECK:
If the power cord is connected to a power controller like a UPS, make sure that it is
powered on.
2. Remove the front bezel.
3. Press the power switch located on the front
of the front panel.
After a while, the “NEC” logo will appear
on the screen.
IMPORTANT:
Do not turn off the power before you see
the “NEC” logo and a character below
the logo.
While the “NEC” logo is displayed on the screen, NEC Express5800/ft series is
performing a power-on self test (POST) to check itself. For details, see “POST Check”
described later in this chapter. Upon the completion of POST, Windows Server 2003 will
start.
CHECK:
If the server finds errors during POST, it will interrupt POST and display the error
message. See Chapter 7.
Power switch
To Next Page
Loading...