NEC Express5800 320Fd-MR - Monitoring Configuration

System Configuration 4-25
Monitoring Configuration
Select “Monitoring Configuration” on the Server menu and press Enter to display the following
screen.
Option Parameter Description
FRB-2 timer Disabled
[Enabled]
Select whether or not to enable the FRB-2 timer.
PCI Enumeration
Monitoring
Disabled
[Enabled]
Select whether or not to enable the function to monitor
PCI Device scan.
PCI Enumeration
Monitoring Timeout
60-[180]-1200 Set the timeout for PCI Device scan. (unit: second)
Option ROM Scan
Monitoring
Disabled
[Enabled]
Select whether or not to enable the function to monitor
the extended ROM scan.
Option ROM Scan
Monitoring Timeout
60-[300]-1200
Set the timeout of the extended ROM scan. (unit:
second)
OS Boot Monitoring Disabled
[Enabled]
Select whether or not to enable the function to monitor
OS boot-up. If you are starting up from an OS with no
NEC ESMPRO Agent installed, disable this option. If
you use Disaster Recovery Option for ARCServe,
select [Disabled].
OS Boot Monitoring
Timeout
60-[600]-1200 Set the timeout at OS boot-up. (unit: second)
POST Pause Monitoring Disabled
[Enabled]
Set whether or not to enable the POST monitoring
function during boot pause. (unit: second)
MainAdvancedSecurityServerBootExit
ftServerSetup
F1Help↑↓SelectItem-/+ChangeValuesF9SetupDefaults
EscExit←→SelectMenuEnterSelectSub-MenuF10SaveandExit
MonitoringConfiguration ItemSpecificHelp

Disables/enablesthe
FRB-2Timer.

FRB-2Timer[Enabled]

PCIEnumerationMonitoring:[Enabled]
PCIEnumerationMonitoringTimeout:[180]

OptionROMScanMonitoring:[Enabled]
OptionROMScanMonitoringTimeout:[300]

OSBootMonitoring:[Enabled]
OSBootMonitoringTimeout:[600]

POSTPauseMonitoring:[Enabled]
POSTPauseMonitoringTime-out[180]