4-34 System Configuration
Emulex BIOS
Emulex BIOS Configuration utility makes settings of the standard implemented Fibre Channel
controller. You can start it up by simple key operation during POST execution without using any
special startup disk.
IMPORTANT:
When setting up the system or replacing Fibre channel controller, configure the setting
referring to Chapter 4 of User’s Guide (Setup).
If you do not configure the above setting of User’s Guide (Setup), the screen of this utility
may not be displayed or an error may occur during POST execution.
Starting the Emulex BIOS
Press Alt and E on the Emulex prompt screen during POST execution.
To Next Page
Loading...