2-20 General Description
BASIC OPERATION
This section describes basic operation procedures of NEC Express5800/ft series.
Installing/removing the front bezel
When you power on/off the server or remove/install CPU/IO module, remove the front
bezel.
IMPORTANT:
The front bezel can only be removed by unlocking the lock with the security key
attached.
(1) Insert the product-accessory security key into the key slot and push lightly. Turn the key to the
left to unlock.
(2) Hold the right edge of the front bezel
and pull it forward.
(3) Slide the front bezel to take the tab off
the frame and remove the front bezel.
When attaching the front bezel, hook the left tab into the server’s frame first, then push forward on
the right side.
To Next Page
Loading...