NEC Express5800 320Fd-MR - Page 104

4-14 System Configuration
Option ROM Configuration
When you select “Option ROM Configuration” in the Advanced menu, the following screen
appears.
 
Refer to the table below for information on options.

Option Parameter Description
PCI Slot 1 (onboard) Option ROM Enabled
[Disabled]
If “Enabled” is selected, the extended ROM of
the PCI card installed on PCI Slot 1 is initialized.
Note: this option is displayed only when a PCI
card is installed.
PCI Slot 2 (lower) Option ROM Enabled
[Disabled]
If “Enabled” is selected, the extended ROM of
the PCI card installed on PCI Slot 2 is initialized.
Note: this option is displayed only when a PCI
card is installed.
PCI Slot 3 (upper) Option ROM Enabled
[Disabled]
If “Enabled” is selected, the extended ROM of
the PCI card installed on PCI Slot 3 is initialized.
Set this option to “Enabled” for the server.
Embedded SAS Option ROM [Enabled]
Disabled
If “Enabled” is selected, SAS extended ROM
embedded in the motherboard is initialized.
Set this option to “Disabled” for the server.
MainAdvancedSecurityServerBootExit
ftServerSetup
F1Help↑↓SelectItem-/+ChangeValuesF9SetupDefaults
EscExit←→SelectMenuEnterSelectSub-MenuF10SaveandExit
OptionROMConfiguration ItemSpecificHelp

EnablesEmbeddedSAS
OptionROMtoboot
fromthedevice.
Defaultstate:ENABLED

EmbeddedSASOptionROM:[Enabled]

EmbeddedPXE#1OptionROM:[Enabled]
EmbeddedPXE#2OptionROM:[Enabled]