NEC Express5800 320Fd-MR - Page 108

4-18 System Configuration
Select “Set Supervisor Password” or “Set User Password” and press Enter to display the following
pop-up screen. The screen below shows when “Set Supervisor Password” is selected.
Set a password on this pop-up screen. Enter a password of up to seven alphanumeric characters and
symbols from the keyboard.
IMPORTANT:
 User password setup is not available before Supervisor password setup.
 Do not set any password before installing the OS.
 If you forget your password, contact your sales agent.
See the table below for setup options on the screen.
Option Parameter Description
Supervisor
Password Is
[Unset]
Set
Indicates Supervisor password setup status (view
only).
User Password
Is
[Unset]
Set
Indicates User password setup status (view only).
Set Supervisor
Password
[Enter]
Press Enter to display the supervisor password
entry screen. This option is available only when
you log into the SETUP utility with the supervisor
password.
Set User
Password
[Enter]
Press Enter to display the user password entry
screen. With a user password, accessing the
SETUP menus is restricted.
MainAdvancedSecurityServerBootExit
ftServerSetup
F1Help↑↓SelectItem-/+ChangeValuesF9SetupDefaults
EscExit←→SelectMenuEnterSelectSub-MenuF10SaveandExit

SupervisorPasswordIs:Unset
UserPasswordIs:Unset

SetSupervisorPassword[Enter]
SetUserPassword[Enter]

Passwordonboot[Disabled]
ItemSpecificHelp

SupervisorPassword
controlsaccesstothe
setuputility.
SetSupervisorPassword
EnterNewPassword[

]

ConfirmNewPassword[]
