5-16 Installing and Using Utilities
# /opt/nec/esmpro_sa/bin/ESMRestart
DataViewer Display of NEC ESMPRO Manager When System Configuration Is
Changed
If CPU module is started/stopped with dataviewer is on the screen, wait for about five minutes and
operate “Reconstruct the tree” on dataviewer.
ntagent Memory Usage
When dataviewer appears, the memory usage of ntagent increases about 10KB per hour. Do not
always display dataviewer, but display it only when failure occurs.
USB Device and Window Displaying
On dataviewer window of NEC ESMPRO Manager, if mouse, keyboard or display apppears
because USB is disabled, the details are shown as unknown.
CPU Information
If you select [CPU Module] – [CPU] in the [ft] tree of the DataViewer, unknown or incorrect
information appears in some information items.
The CPU information can be viewed by selecting [System] – [CPU] in the [ESMPRO] tree.
CPU Module Status
“CPU module” icon status in “ft” tree on dataviewer remains green even if CPU module is stopped.
If you receive notification that indicates system configuration is changed, confirm the current status
on “Status” in “CPU module” – “General information”.
PCI Module Status
When a cable is detached from the onboard ethernet board, “Status” of “PCI module” – “General
information” of “ft” tree on dataviewer remains the same. Confirm the current status on “Status” of
“PCI module” – “Ethernet board”.
Change of Installation Status of CPU and PCI Modules
If CPU module/PCI module configuration of the system is changed into dynamic while displaying
the server information on dataviewer, the information on the dataviewer may differ from the current
system information because the information does not reflect the system configuration change. Run
the following command and reboot NEC ESMPRO Agent, and reconfigure the tree on dataviewer.
# /opt/nec/esmpro_sa/bin/ESMRestart
To Next Page
Loading...