5-34 Installing and Using Utilities
The table below shows the component-specific maintenance functions executable from NEC
ESMPRO.
Dump harvest
Dump harvest during
system operation
Board switch
Component
R L R L R L
CPU module – – – – – –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using ft server utility
: Supported
–: Not supported
Bus reset Change of primary SCSI bus
Component
R L R L
SCSI bus – – – –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using ft server utility
: Supported
–: Not supported
The table below shows the support of the whole system setup functions.
Quick dump Auto firmware update Auto module start
Component
R L R L R L
Whole system – – – – – –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using ft server utility
: Supported
–: Not supported
The table below shows the support of the preventive disk maintenance (S.M.A.R.T.) setup function.
Preventive disk maintenance (S.M.A.R.T.) setup
Component
R L
SCSI disk – –
R: Remote. Executable from remote management PC by using NEC ESMPRO Manager
L: Local. Executable on local server by using ft server utility
: Supported
–: Not supported
To Next Page
Loading...