Installing and Using Utilities 5-49
Even if you do not have the image data of firmware for update, the firmware can be copied from the
other module.
By starting the module, the firmware will be updated automatically. However, when the [Enable
automatic firmware update] property is disabled, follow the steps below to update the firmware:
1. Start the system using the module of the firmware copy source.
See the current status by the “Status” indication on the target component screen of the
copy destination and verify that it is stopped.
2. On the [Update] screen of the target component, click [Firmware update].
3. When a firmware updating dialog appears, check [Copy online BIOS image to Offline]
and execute it.
Firmware is updated by copying the firmware on the online side to the offline side.
4. Start the stopped module.
To Next Page
Loading...