Maintenance 6-7
6. Select [Test and diagnostics].
Select [End-User Mode] and the system diagnostics starts. The diagnostics will be
completed in approximately three minutes.
When the diagnostics is completed, the screen of the display changes as shown below:
Diagnostics tool title
Shows the name and version of the diagnostic tool.
Test window title
Shows the progress of the diagnostics. “Test End” is displayed when the diagnostics
completes.
Test result
Shows the start, end, and elapsed time and completion status of the diagnostics.
Guideline
Shows the details of the keys to operate window.
Test summary window
Shows the results of each test that executed the diagnostics. Move the cursor and press the
Enter key on the cursor line to display the details of the test.
When an error is detected by the system diagnostics, the relevant test result in the test
summary window is highlighted in red, and “Abnormal End” is displayed in the result on
the right side.
Move the cursor to the test that detected the error, and press the Enter key. Record the
error message that has been output to the Detail Information screen and contact your sales
agent.
Diagnostics tool title
Test window title
Test result
Test summary
window
Guideline
To Next Page
Loading...