2-10 General Description
(1) CPU/IO module 0
This is a module with a set of CPU (processor), memory (DIMM), PCI board, and cooling fan
unit.
(2)-1, 2 PCI slots 1, 2, 3
(2)-1: A Low Profile type PCI board is mounted on this slot (64 bit 133MHz 3.3V PCI).
(2)-2: This is not used with this server model.
(2)-3: Fibre Channel board is implemented.
(3)-0, 1, 2 USB connector 0, 1, 2
These connectors attach USB2.0-interface-supported devices.
(4) Monitor connector
This is used to attach a display device.
(5)-1, 2 serial port 1, 2 connector
This is used to attach a serial interface connector.
This can be used only for maintenance.
(6)-1 AC inlet A connector
A power cord is connected to this socket (for the CPU/IO module 0). If you want make the
CPU/IO module 0 primary, connect a power cord to this inlet first.
(6)-2 AC inlet B connector
A power cord is connected to this socket (for the CPU/IO module 1). If you want to make the
CPU/IO module 1 primary, connect a power cord to this inlet first.
(7) LAN connector (VTM)
This is not used with this server model.
(8)-1 LINK/ACT LED (VTM)
This is not used with this server model.
(8)-2 Speed LED (VTM)
This LED indicates the transfer speed of LAN (VTM).
(9) DUMP (NMI) switch
This switch executes a memory dump.
Press the DUMP switch on the primary CPU/IO module, whose POWER LED has been blinking,
for four to eight seconds.
(10)-1, 2 PCI slot status LEDs (Slot 1, 2, 3)
These LEDs display the status of the PCI slot. The status is shown by the display combination of
the 2 LEDs (Refer to the chart on p 2-19).
(11)-1 CPU/IO module status LED 1 (amber)
This LED indicates the status of the CPU/IO module. When the module is successfully running,
the LED is powered off. If a module has a problem, the LED illuminates in amber.
To Next Page
Loading...