ESX Server Operation and Configuration 3-5
When you stop the PCI module and a failover occurs, the following event or change will
occur:
- The screen of the server turns black and nothing is displayed thereafter (this is not a
failure).
- The DVD-ROM drive becomes unable to use (this is not a failure).
- The status LEDs of the PCI module change as follows.
[Indications of the status LEDs]
LED Secondary*
Primary*
1
CPU/IO module status LED1 Amber -
2
CPU/IO module status LED2 - Green blinking
*indicating primary or secondary after failver
4. Restart the PCI module.
From the ft server utility, click [Start] of [Start/Stop] to the PCI module which was stopped in
the step 3, and the PCI module will be started. Once the PCI module is started, PCI module
diagnosis and PCI module duplication are performed.
The PCI modules’ status LEDs changes as shown below:
[Indications of the status LEDs]
Immediately after the PCI module startup until the completion of diagnosis
LED Secondary Primary
1
CPU/IO module status LED1 - -
2
CPU/IO module status LED2 - Green blinking
When duplication of disks is started after the completion of PCI module diagnosis
LED Secondary Primary
1
CPU/IO module status
LED1
-
-
2
CPU/IO module status
LED2
Green blinking Green blinking
To Next Page
Loading...