System Configuration 4-9
Available options in the Main and descriptions are listed below.
Option Parameter Description
System Time HH:MM:SS Specify the system time.
System Date MM/DD/YYYY Specify the system date.
CPU Speed XXXX MHz Displays the processor clock frequency.
Physical CPUs X Displays the number of processor installed.
System Memory XXXX KB Displays the size of system memory.
Extended Memory
XXXX MB Displays the size of extended memory.
Cache Ram XXXX KB Displays the capacity of L2 cache.
SATA AHCI
Enable
[Disabled]
Enabled
Specify whether or not to enable AHCI mode.
[ ] factory default
IMPORTANT:
Check and adjust the system clock before operation in the following conditions.
- After transporting the equipment
- After storing the equipment
- After the equipment halt under the conditions which is out of the guranteed environment
conditions (Temperature: 10 to 35°C, Humidity: 20 to 80%).
Check the system clock once in a month. It is recommended to operate the system clock using a
time server (NTP server) if it is installed on the system which requires high level of time accuracy.
If the system clock goes out of alignment remarkably as time goes by, though the system clock
adjustment is performed, contact your sales agent.
Do not change “SATA AHCI” as “Enabled.” The BIOS version may become unable to display on
the ft Server Utility.
To Next Page
Loading...