CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 101 – NWA-008847-001 Rev.3.0
a6ch1001.fm
(4) To provide releasing the path by RTP monitoring, do the following programming.
[Series 3700 R12.2 software required]
(5) To provide registering fault information (fault kind 43) by RTP monitoring, do the following
programming.
[Series 3700 R12.2 software required]
DESCRIPTION DATA
Provide releasing the path by RTP monitoring
via SIP card.
(1)
(2)
672
0: To provide
1: Not provided
NOTE: When the second data of CM08>672 is set to 0, the path is released when the SIP card does
not receive RTP for 10 seconds after establishing the path.
DESCRIPTION DATA
Provide registering fault information (fault
kind 43) by RTP monitoring via SIP card.
(1)
(2)
679
0: Not provided
1: To provide
NOTE1: This command is effective when the fault information (fault kind 43) is assigned by CMEA
Y=2.
NOTE2: When the second data of CM08>679 is set to 1, the registering fault information (fault kind
43) by RTP monitoring via SIP card is performed as follows.
- When releasing the path by RTP monitoring via SIP card is provided (CM08>672: 0),
the fault information (fault kind 43) is registered whenever the path is released by RTP
monitoring.
- When releasing the path by RTP monitoring via SIP card is not provided (CM08>672:
1), the fault information (fault kind 43) is registered only one time.
START
CM08
END
START
CM08
END
JULY/01/2006
VoIP LOG COLLECTION
To Next Page
Loading...
