CHAPTER 2 TROUBLESHOOTING
– 201 – NWA-008847-001 Rev.3.0
a6ch2001.fm
Remedial Action on Each Lamp Status
Continued on next page
CARD NAME
LAMP
STATUS
FAULT
CONTENT
REMEDIAL ACTION
PN-32IPLA/
PN-32IPLA-A
(IP-PAD)
RUN lamp is not
flashing
Abnormal opera-
tion of IP-PAD
card
Confirm whether the MODE switch
is set to 0, 3, or 4.
0: Auto Negotiation ON
(Recommended)
3: Auto Negotiation OFF
(10 Mbps fixed)
4: Auto Negotiation OFF
(100 Mbps fixed)
Confirm the programming data:
CM0A.
Reset the MB switch.
(Down Up Down)
If the fault cannot be cleared,
replace the card.
PN-32IPLA/
PN-32IPLA-A
(IP-PAD)
[PZ-M571/
PZ-M632]
LINK lamp is not
on
LAN connection
failure
Check to see if the LAN cable is
correctly connected.
Confirm the condition of the LAN
device (such as power of the HUB)
connected to the IP-PAD.
Confirm whether the MODE switch
is set to 0.
If the fault cannot be cleared,
replace the card.
1
2
3
4
1
2
3
4
OCTOBER/14/2005
FAULT DIAGNOSIS AND TROUBLESHOOTING
To Next Page
Loading...
