NEC PH2601QL - Page 115

98
5. Using On-Screen Menu
[INSTALLATION(2)]
[SHUTTERSETTINGS]
Enablinganddisablingthelensshutterfunction.Youcanalsosethowlongthelightwilltaketofadeinandfadeout
wheneithertheSHUTTERbutton.
POWERON
SHUTTER
OPEN Whenthepoweristurnedon,thelensshutteropensandthepictureisprojected.
CLOSE Thelensshutterremainsclosedevenwhenthepoweristurnedon.Pressthe
SHUTTERbuttontoopentheshutterandprojectthepicture.
PICTUREMUTE
SHUTTER
OPEN
Thelensshutterremainsopenwhenthepicturedisappearse.g.whentheinput
terminal is switched and so on.
CLOSE
Thelensshuttercloseswhenthepicturedisappearse.g.whentheinputterminal
is switched and so on.
FADEINTIME SethowlongthelightwilltaketofadeinaftertheSHUTTERbuttonispressed.
Thetimecanbesetfrom0to10secondsinincrementsof1second.
FADEOUTTIME SethowlongthelightwilltaketofadeoutaftertheSHUTTERbuttonispressed.
Thetimecanbesetfrom0to10secondsinincrementsof1second.
UsingtheReferenceLensMemoryFunction[REF.LENSMEMORY]
ThisfunctionservestostoretheadjustedvaluescommontoallinputsourceswhenusingtheLENSSHIFT,ZOOM
andFOCUSbuttonsoftheprojectorortheremotecontrol.Theadjustedvaluesstoredinmemorycanbeusedasa
reference to the current.
PROFILE ................ Select a stored [PROFILE] number.
STORE
................... Stores the current adjusted values in memory as a reference.
MOVE
.................... Applies the adjusted reference values stored in [STORE] to the current signal.
RESET
.................... Reset selected [PROFILE] number [REF. LENS MEMORY] to the factory default settings.
LOAD BY SIGNAL
.. When you switch signals the lens will shift to the lens shift, zoom, and focus values for the selected [PRO-
FILE] number.
If no adjusted values have been saved to [LENS MEMORY], the lens will apply [REF. LENS MEMORY]
adjusted values. Alternatively, if no adjusted values have been saved to [REF. LENS MEMORY], the unit will
return to factory default settings.
FORCED MUTE
...... To turn off the image during lens shift, select [YES].
NOTE:
• Adjustedvaluesin[REF.LENSMEMORY]willnotbereturnedtodefaultwhenperforming[CURRENTSIGNAL]or[ALLDATA]for
[RESET]fromthemenu.
• Tostoreadjustedvaluesforeachinputsource,usetheLensMemoryfunction.(→page89)