5-18 Installing Options
2. Remove the front panel (see “Removing the Front Panel
— Minitower,” later in this chapter).
3. Remove the screw holding the top cover to the rear of the
chassis (see the figure in “Removing the Minitower Side
Covers”).
4. Lift the back end of the cover up about an inch to free its
restraining tabs.
5. Slide the top cover toward the front of the chassis, then
lift the cover off the chassis (see the following figure).
Removing the minitower top cover
A
– Top Cover Tabs
B
– Top Cover
Replacing the Minitower Top Cover
Replace the top cover as follows.
1. Align the top cover over the chassis about an inch beyond
the front of the chassis. Hold the rear of the cover higher
than the front (see the preceding figure).
To Next Page
Loading...
