NEC POWERMATE ES 5250 - Removing an Expansion Board - Minitower

Installing Options 5-59
Installing an expansion board — minitower
A
– Screw
B
– Expansion Board
12.
Attach any signal cables required by the expansion board.
13.
If you slid the system board partway out of the chassis,
slide it back in (see “Closing the Chassis Floor”).
14.
Place the system unit upright and swivel the feet out,
perpendicular to the system unit.
15.
Replace the left side cover (see “Replacing the Minitower
Side Covers”).
Removing an Expansion Board — Minitower
To remove an expansion board, use the following steps.
1.
Remove the left side cover (see “Removing the
Minitower Side Covers”).
2.
Swivel the two feet inward, out of the way.