Installing Options 5-91
8. Replace the front panel (see “Replacing the Front
Panel — Minitower”).
9. Replace the left side cover (see “Replacing the Minitower
Side Covers”). If you removed the top cover, replace it
(see “Replacing the Minitower Top Cover”).
10. Run the Setup program to set the new configuration (see
“CMOS Setup Utility” in Chapter 3).
Installing a 3 1/2-Inch Hard Drive — Small Desktop
The small desktop system has an internal hard drive bay
located near the top front of the chassis. You can upgrade the
system by replacing the existing hard drive with a higher
capacity drive available from NEC CSD.
To install a 3 1/2-inch internal hard drive, proceed as follows.
1. Follow the preinstallation instructions that come with
your device, such as setting jumpers.
See “Preparing the Device” for device preparation
information.
2. Remove the system unit cover (see “Removing the Small
Desktop or Desktop Cover”).
3. If a currently installed hard drive is being replaced:
Label the IDE device signal and power cables
connected to the drive and then disconnect them.
Remove the two screws securing the internal hard
drive bracket to the braces on the top of the chassis
(see the following figure).
Lift the internal hard drive bracket and hard drive off
of the chassis.
Remove the screws securing the drive to the bracket.
To Next Page
Loading...
