NEC POWERMATE ES 5250 - Diskette Drive Cabling; Internal SCSI Device Cabling

5-74 Installing Options
4. If you are installing a CD-ROM drive or DVD-ROM
drive and your system has speakers, connect the audio
cable to the CD Audio In connector on the riser board or
an audio board (see the instructions that come with the
drive).
Diskette Drive Cabling
The following procedure describes how to cable a diskette
drive.
1. Connect the diskette drive signal cable connector to the
signal connector on the diskette drive.
2. Locate an available power connector coming from the
power supply.
3. Connect the power cable to the power connector on the
device.
Internal SCSI Device Cabling
Use the following procedure to connect an internal SCSI
device.
1. Connect the SCSI device to the last free connector on the
SCSI device cable (see the following figure).
See the documentation that comes with the SCSI device
for information about terminating and jumpering the
device.
2. Locate an available power connector coming from the
power supply.
3. Connect the power cable to the power connector on the
SCSI device.