Configuring the System 3-37
Locating system board jumpers
A
– JVGA1 (VGA Mode)
C
– JP1 (Power On Mode)
B
– JBAT1 (CMOS Clear)
Setting Onboard Video
If you add a graphics board to your system, you must disable
the onboard video by changing the jumper setting on block
JVGA1 (see the following table).
Onboard Video Jumper Settings
JVGA1 Function
1-2 Factory setting. Enables onboard video.
2-3 Disables onboard video.
To Next Page
Loading...
