NEC POWERMATE ES 5250 - Installing a 5 1;4-Inch Device - Minitower

Installing Options 5-89
8. Replace the front panel.

In a small desktop system see “Replacing the Front
Panel — Small Desktop.”

In a desktop system, see “Replacing the Front
Panel — Desktop.”
9. Replace the system unit cover (see “Replacing the Small
Desktop or Desktop Cover”).
10. Run the Setup program to set the new configuration (see
“CMOS Setup Utility” in Chapter 3).
Installing a 5 1/4-Inch Device — Minitower
Use the following procedure to install a 5 1/4-inch device in a
5 1/4-inch accessible device bay.
Note:
A 3 1/2-inch device can also be
installed in a 5 1/4-inch accessible device bay.
Place the device in a 5 1/4-inch frame adapter
and then follow the instructions in this section.
1. Follow the preinstallation instructions that come with
your device, such as setting jumpers.
See “Preparing the Device” for device preparation
information.
2. Remove the left side cover (see “Removing the
Minitower Side Covers”).
3. Remove the front panel (see “Removing the Front
Panel — Minitower”).