Configuring the System 3-41
Zip Drive Jumpers
The three-position jumper block for the Zip drive is located
on the rear of the drive. The following description applies
when the rear of the drive is viewed with the IDE connector
to the left of the jumper block, and the power connector to the
right.
Drive 0 Select (Master Drive Select) — right two pin sets
jumpered
Drive 1 Select (Slave Drive Select) — right-most pin set
jumpered
Cable Select Mode — all three pin sets jumpered
Tape Backup Unit Jumpers
Cable Select jumper — (1,2) Not used
Master device (5,6)
Enabled, DS jumpered
Disabled, DS open (factory default)
Slave device (3,4)
Disabled, open (factory default)
Enabled, jumpered
To Next Page
Loading...
